Thekonksu tüüpi kuulipuhumismasinon üldiselt suurema välimusega ja paigaldusprotsess on suhteliselt keerulisem kui väikeste seadmete oma. Õige paigaldus ja katsemasin on hilisemate seadmete normaalse töö tagamise võti. Kvalifitseerimata esmaste toimingute korral peavad kasutajad rangelt järgima vastava personali juhiseid või juhiseid järgima. Volitamata kasutamine võib seadmele kergesti pöördumatut kahju tekitadahaaklaskega lõhkamismasin. Theshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Thekonksu tüüpi kuulipuhumismasin is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Theprecautions for the installation and debugging of the relevant components are introduced below.
1. Laskepritseseade:
Theshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. Tõstuk ja kruvikonveier:
Esmalt tehke koormuseta test, et kontrollida, kas tõstekopp ja spiraalsed labad töötavad õiges suunas, seejärel pingutage tõstuki rihma mõõduka pingutuseni, et vältida kõrvalekaldeid, ja seejärel kontrollige koormustesti töö- ja ülekandevõime, olenemata imelikkusest, mürast ja vibratsioonist, kontrollige ja eemaldage takistused.
3. Pill-liiva eraldaja:
Kõigepealt kontrollige, kas jäära liikumine on paindlik, ja seejärel kontrollige eraldusplaadi õiget asendit, seejärel, kui tõstuk on koormatud ja silutud, voolab pidevalt terasest laske ja kontrollige, kas terasest lasud voolavad välja ja kukuvad kui renn tühjeneb